Results 1 to 4 of 4

Thread: iPhone 4G : How to Remove / Replace Battery

          
  1. #1
    Super Moderator GSM_Update's Avatar
    Join Date
    Aug 2010
    Posts
    2,467
    Thanks
    56
    Thanked 189 Times in 131 Posts

    Default iPhone 4G : How to Remove / Replace Battery



    Step 1 — Rear Panel


    • Before disassembling your iPhone, be sure the silent switch is activated and your iPhone is powered off.



    Step 2


    • Remove the two 3.6 mm Phillips screws next to the dock connector.






    Step 3


    • Push the rear panel toward the top edge of the iPhone.
    • The panel will move about 2 mm.











  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many
    Official iPhone Unlock - iUnlockStore World's most trusted iPhone Unlocking Solution -
    Official iPhone Unlock
     

  3. #2
    Super Moderator GSM_Update's Avatar
    Join Date
    Aug 2010
    Posts
    2,467
    Thanks
    56
    Thanked 189 Times in 131 Posts

    Default

    Step 4



    • Remove the rear panel from the iPhone.



    Step 5 — Battery



    • Remove the single 2.5 mm Phillips screw securing the battery connector to the logic board.





    Step 6



    • Use an iPod opening tool to carefully pry the battery connector up from the ends closest to the top and bottom edges of the iPhone.


    • Do not pry against the pressure contact.

    • Remove the antenna contact from the iPhone.










    Step 6



    • Use an iPod opening tool to carefully pry the battery connector up from the ends closest to the top and bottom edges of the iPhone.


    • Do not pry against the pressure contact.

    • Remove the antenna contact from the iPhone.








  4. #3
    Super Moderator GSM_Update's Avatar
    Join Date
    Aug 2010
    Posts
    2,467
    Thanks
    56
    Thanked 189 Times in 131 Posts

    Default



    Step 7



    • Use the clear plastic pull tab to gently lift the battery out of the iPhone.

    • Be careful when removing the battery with the plastic pull tab. On some units, Apple uses an excessive amount of glue, making it virtually impossible to remove the battery in this fashion (with the tab possibly tearing due to excessive force).

    • For batteries that "stick", you could use the iPod opening tool to assist (take extra care whilst doing so).

    • Remove the battery.


    • Before reconnecting the battery connector, be sure the pressure contact (shown in red) is properly positioned next to the battery connector.


    • Before reassembly, be sure to clean all metal-to-metal contact points on the pressure contact as well as its contact point on the rear panel with a de-greaser such as windex. The oils on your fingers have the potential to cause wireless interference issues.

  5. #4
    Junior Member nalinikanniappan's Avatar
    Join Date
    Mar 2011
    Posts
    14
    Thanks
    1
    Thanked 1 Time in 1 Post

    Default

    Nice post

    thanks for ur sharing

    good luck

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •